V9 Manual

Flipper is pre-programmed for many TVs and STBs (Cable/Satellite Boxes). Follow these simple steps to set up your remote.

Basic Setup

1️⃣ Set TV Control

📌 Press VOL
✔ If Volume works, go to Step 2
✔ If not, then:
➡ Press and hold TV until the light turns solid, then enter the 4-digit TV code
➡ Test Power & Volume

(No STB? TV Only Mode)
📌 Press and hold TV until solid, then enter 970

2️⃣ Set STB (Cable/Satellite Box) Control

📌 Press CH
✔ If channels change, setup is complete ✅
✔ If not, then:
➡ Press and hold STB until the light turns solid
➡ Enter the 4-digit STB code
➡ Test Power & Channel

(No STB? TV Only Mode)
📌 Press and hold TV until solid, then enter 970

3️⃣ Set Favorites (Optional)

📌 If you want Favorites, go to the Manual "Favorites" Section

Troubleshooting

1️⃣ If the Red Light Doesn’t Work Correctly

📌 Press and hold ADD until solid, then enter 956 (light blinks out)
📌 Repeat with STB and TV buttons

2️⃣ Full Reset & Re-Sync

📌 Press and hold ADD until solid, then enter 954 (light blinks out)
✔ Re-sync TV & STB using steps above