Flipper is an IR remote and requires direct line of sight to control devices.
Issue:
If the user points Flipper away from the devices, one device may turn on while the other turns off, causing them to be out of sync.
Solution: Modify Flipper to Control Only the TV Power
📌 Steps to Modify Flipper
Please make sure that both the TV and STB are close to one another and in direct line of sight. We need to be at least 4-5 feet away so the IR infrared signal spreads out.
Also allow at least 5 seconds for the devices ot fully power down before pressing on/off again. They are not made for rapid on/off cycles.
(1) Set TV Only Power Mode:
- Press and hold ADD until the light turns solid, then enter 999
(2) Check Standby Mode on STB:
- Some STBs (Set-Top Boxes) have a Standby Mode that can interfere with power settings.
- If your STB has this feature, disable it.
- See Standby Mode guides for Dish and ATT for details.
✔ Now, Flipper will only turn the TV on/off!
✔ STB power will remain unaffected.